Hello,

I have a turblown built 13brew, also adaptronic PnP supplied by him. All my trigger wires are hooked up according to the pinout diagram, but T2 is still not receiving a trigger signal, or spark. I have switched out the coil in the hope it was bad, but to no luck. I'm also running factory trigger sensors. Everything has been setup in WARI, (custom, then direct fire 2 rotor). But still no spark.

-JGappa

 

The most common issue with direct fire conversions are wiring the coils. However, as a preliminary troubleshooting measure, what does the IGN LEDs do on top of the ECU? You can email Adaptronic Tech Support with your ROM, as well as a video of the LED pattern if you wish to assist in troubleshooting.

 

Thank you for a reply, Daniel. Here is a little clip I just took of my ECU while cranking.

 

Stock CAS?

 

Hi John,

I sent you an email back at tech@ asking for a copy of the ECU file, were you able to see it?

Thank you.
Mark