A long long time ago, I can still remember... Wait, sorry, that's a song..

A long time ago, in a galaxy far far away, I ran my megasquirt off of the Mazda factory water temp sensor. I'm now running all the latest and greatest software after dusting off the MS for the first time in about 4 years, but this time I have a GM water temp sensor. (MS1 chip on a 2.2 board)

Now on the GM sensor, the water temp is obviously off, spiking up to 90* C almost immediately.

I can't remember how to switch back to a GM "map," I know I had to use EasyTherm to load the file back in the day, but I also had to use a boot jumper!
Do I have to go back to EasyTherm, and if so, I'm assuming there's a default map for a GM temp sensor now-a-days?

Thanks!

~Wonko

 

The firmware defaults to the GM lookup table for water temp. You can just reload whatever firmware you're using and then reload your settings (just save them off before reloading the firmware).

Ken

 

Great, I was hoping it would be that easy.. Thanks Ken!