Megasquirt MSI 2.2 runing spark
#1
i play with my wankel
Thread Starter
Join Date: Jul 2005
Location: North Manchester, Indiana
Posts: 1,630
Likes: 0
Received 0 Likes
on
0 Posts
MSI 2.2 runing spark
Ok so I've got an MSI 2.2 (green pcb) and I want to run spark now. So from what I've gathered with the MS1 board I need the Zeal board, wired like the pic below, and the pull up resistors installed at the LEDs. Then obviously changes in Map for ignition. Just making sure thx guys
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Basically. You can use the Zeal card, or make a dual LM1815 circuit on another board. The Zeal is easiest and also comes with a few other features.
Like other boards, the 2.2 needs pullup resistors on the LEDs.
Like other boards, the 2.2 needs pullup resistors on the LEDs.
#3
i play with my wankel
Thread Starter
Join Date: Jul 2005
Location: North Manchester, Indiana
Posts: 1,630
Likes: 0
Received 0 Likes
on
0 Posts
As always thanks a ton Aaron, I just want to clarify before I jump into this. The pullup resistors on the LEDs need a 5v supply right?
Thread
Thread Starter
Forum
Replies
Last Post