List of seats that fit and dont fit.
#926
Eats, Sleeps, Dreams Rotary
my plan was the Sendai model since the shoulders are narrower was going to mix it with either the feed slide rails since they look to be a fairly shallow slide system compaired to bride or I’ll go fixed and go with street faction mounts. Honestly not to concerned with if my seat moves or not. Once it’s in place I never mess with it.
#927
Full Member
#928
Junior Member
#931
Full Member
I found this quote by searching this thread. First result.
Sparco R100's fit without modification.
Very light touching on the door cards, not much though.
Used Planted seat brackets and Sparco rails.
-Geoff
Sparco R100's fit without modification.
Very light touching on the door cards, not much though.
Used Planted seat brackets and Sparco rails.
-Geoff
Last edited by NightWalker86; 10-18-23 at 09:13 PM.
The following 2 users liked this post by NightWalker86:
Ls3rx-7 (10-19-23),
madhat1111 (10-20-23)
#932
Eats, Sleeps, Dreams Rotary
PSA: don’t buy the Kawai Works super low seat rails if you are taller than about 5’9” or 5’10”, it’s designed for short bastards and doesn’t go far back enough.
#933
Full Member
I’m looking at this seat from bridgemoto, I attached a picture of the specs. Seem to be pretty close to brides Edirb but I’m having trouble finding rails that will fit and make sure I can use my factory door panels without modifying the seat, and will drop the seat an inch or two
#934
Full Member
Bridgemoto XL bucket seat with Ronin rails fits perfect. I’m 6ft 230lbs modified the rails so seat sits as far back as possible. Can get in and out of the car easily even without removing my steering wheel. Just ever so slightly touches the door panel but that may be me needing to readjust the rails. I feel like I’m sitting a little crooked.
#935
Bridgemoto XL bucket seat with Ronin rails fits perfect. I’m 6ft 230lbs modified the rails so seat sits as far back as possible. Can get in and out of the car easily even without removing my steering wheel. Just ever so slightly touches the door panel but that may be me needing to readjust the rails. I feel like I’m sitting a little crooked.
Thread
Thread Starter
Forum
Replies
Last Post
p00shy
3rd Generation Specific (1993-2002)
17
12-22-12 12:34 AM
neo_omega
3rd Generation Specific (1993-2002)
14
04-25-02 02:26 PM