Haltech Sprint RE FC3S Install Document (Nov 02 2011)
#26
LOPEY IDLE
ok so I think I get this now. so I would take the two 12v leads ecu and sencer supply run them to the same relay and then from the relay I send a wire out to be spliced to each injecter. and the relay is powerd by by a 12v switched source from some were in the car and then grounded, and I would throw a fuse in there as well somewhere. am I right or at least close?
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM