Haltech Need last minute help!
#1
Need last minute help!
i downloaded the k2rd diagrams made the job easy now i need a diagram of the fuel pump and how to run my o2 sensor on a closed loop
also how do i wire my e-fan w/ relay to the harness
also how do i wire my e-fan w/ relay to the harness
Last edited by Alex Rodriguez; 08-09-07 at 10:29 PM.
#3
Wiring up the pump is cake, one orange wire (any) to positive on the battery, the other to the positive terminal on the pump, the negative terminal on the pump goes to ground directly. Note! this is in the manual! read it!
For proper O2 sensor closed loop its recommended that you use either a 3 wire or preferably a 4 wire narrow band sensor, and the connection diagram is also in the manual, as well as a brief explanation on close loop setup.
For proper O2 sensor closed loop its recommended that you use either a 3 wire or preferably a 4 wire narrow band sensor, and the connection diagram is also in the manual, as well as a brief explanation on close loop setup.
#4
Crash Auto?Fix Auto.
iTrader: (3)
Or if your wideband mimics a narrowband with a 0-1v output, that can be fed into the "02" portion of the harness and closed loop can be driven from that. I know the X can't do it from a wideband signal like the E8 an E11v2 can.
From there you just need to configure the settings to match how you'd like you closed loop to operate.
From there you just need to configure the settings to match how you'd like you closed loop to operate.
Trending Topics
#9
Are you sure he's got an S4 TPS in there? it would probably go bananas when you go beyond 1/4 throttle, since it will read 100% like classicauto said. Just find an S5 TPS and you'll save on headache medicine.
#11
ok i got one its in the mail ooooyeahhh...what would do with out the rx7club....umumumum um
now i have a s4 tb , that i spent a long time working on, ie tb mod,porting,painting,removal of unnessary parts
what would be the best way to make this work i know that the tps are diffrent
now i have a s4 tb , that i spent a long time working on, ie tb mod,porting,painting,removal of unnessary parts
what would be the best way to make this work i know that the tps are diffrent
Thread
Thread Starter
Forum
Replies
Last Post
23Racer
Race Car Tech
1
09-21-15 10:48 AM