Hey everyone, I figured out how to use the stock MOP without changing the front plate nor the pump. I'm using the stock one, ther's no need to replace anything, ha ha!:

 

well....?
how

 

Yeah, lets hear. Id like to keep the OMP that will be on my engine.

 

Actually, I just made the stock one mechanical instead of electric.

 

So how did you convert it to mech?

 

Because there are a lot of secrets that go one with the Haltech, I too will keep this as a secret until someone can give me a good E6K map for a GT35/40 setup, unfortunately it goes like this because people are not generous enough to give their maps away-oooh so many hours worth, so figure it out yourself unless someone can help-BTW I have pictures also!!!!!!

 

your corny- if everone had your attitude no one would ever help anyone, just plain gay to be like i know how to do it but wont tell till someone helps me.. i have maps for a t-78

 

Ok, ok here it is, since people are getting mad. I took off the electric motor and made a piece of aluminium with a bolt and 2nutz(1 on the inside and 1on the outer side) so it can be adjustable, works pretty damn good, better than premixing. I hope the picture says it all.

 

when you run slow do you adjust it out and then you give it the gas do you adjust it in , you must be fast,