Haltech injectors?
03-28-10, 07:01 PM
#1
Full Member
Thread Starter
iTrader: (8)
Join Date: Sep 2007
Location: sioux falls, south dakota
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
injectors?
i just picked up an e6k and now i am going to order some bigger injectors to go with my turbo setup. so does it matter if i use high imp or low imp injectors? i was looking at running 4 1000cc or 1600cc top feed rc injectors
04-01-10, 10:12 AM
#2
04-02-10, 11:26 AM
#3
Full Member
Thread Starter
iTrader: (8)
Join Date: Sep 2007
Location: sioux falls, south dakota
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
really whats wrong with rc injectors cause i know a few people that use them and they seem to work really good. what kind do you recommend then?
04-05-10, 11:39 AM
#4
BDC Motorsports
Figure 4x550's (2200cc/min at 40psi base) will support about 260rwhp before the injectors start tagging 90% DC.
2x680's and 2x1680's (4720cc/min) will support right at 500rwhp with inj DC's at 90-92% on race fuel.
So, 4x1000's (4000cc/min) can do about 425rwhp at a 40psi base. Will do about 500 to the wheels at a base pressure of 55psi (~4700cc/min).
B
2x680's and 2x1680's (4720cc/min) will support right at 500rwhp with inj DC's at 90-92% on race fuel.
So, 4x1000's (4000cc/min) can do about 425rwhp at a 40psi base. Will do about 500 to the wheels at a base pressure of 55psi (~4700cc/min).
B
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM