still having ignition system wiring issues
#1
Junior Member
Thread Starter
still having ignition system wiring issues
it seems as though my distributor (b) and (c) termals are always active ground. are the igniters always supposed to be ground? I thought they were only ground when the distributor is lined up with the igniter in order to only ground coil at the right time? keep in mind that this is in a dunebuggy without the stock wiring harness so if you have helpful diagrams or see anything missing in this one all would be helpful.
Video:
https://youtu.be/5bNapiBXSd8
Wiring Diagram I fallowed
http://coachedby.me/wiring-diagram-coil-ignition.html/coil-wiring-diagram-hei-diagrams-and-ignition-webtor-me-new
Video:
https://youtu.be/5bNapiBXSd8
Wiring Diagram I fallowed
http://coachedby.me/wiring-diagram-coil-ignition.html/coil-wiring-diagram-hei-diagrams-and-ignition-webtor-me-new
#2
Junior Member
Thread Starter
so I fallowed this forum to test my igniters and the igniters are ok.
https://www.rx7club.com/1st-gen-arch...nitors-742083/
then I tested my coils, both were good resistance and gave a spark.
with the coils and the igniters working but the spark plugs still not sparking there must be something missing or faulty?
condenser and vacuum advanced timing are not hooked up along with there being no ballast resisters, are any of those things a must have to get the engine to run?
if its none of the above at fault then it must be the distributor cap, ignition rotor, or the point type part inside of the distributor?
https://www.rx7club.com/1st-gen-arch...nitors-742083/
then I tested my coils, both were good resistance and gave a spark.
with the coils and the igniters working but the spark plugs still not sparking there must be something missing or faulty?
condenser and vacuum advanced timing are not hooked up along with there being no ballast resisters, are any of those things a must have to get the engine to run?
if its none of the above at fault then it must be the distributor cap, ignition rotor, or the point type part inside of the distributor?
#3
Junior Member
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
Starfox07
1st Generation Specific (1979-1985)
6
09-17-11 10:04 PM
Medicj02
2nd Generation Specific (1986-1992)
5
12-10-06 06:20 PM
sixtydgree
1st Generation Specific (1979-1985)
7
10-20-05 05:37 PM
AreExSeven
2nd Generation Specific (1986-1992)
3
01-17-03 10:38 AM