12a wont Brap
Thread Starter
Can Post Only in New Member Section
Joined: Aug 2019
Posts: 2
Likes: 0
From: Brisbane
12a wont Brap
Any help would be much appreciated. on occasion my bridgeport apon starting will idle low then start brapping after 20 seconds, only every now and then, today from cold start, idles but no brap, even after a few minutes ?
thanks in advance.
thanks in advance.
Old [Sch|F]ool
Joined: May 2001
Posts: 12,862
Likes: 568
From: Cleveland, Ohio, USA
Problem?
My Group A spec'd bridge port would idle smooth as glass at 800-900rpm. Same for my peripheral port 12A.
If you want it to idle like ****, raise the idle up over 1500 or so.
My Group A spec'd bridge port would idle smooth as glass at 800-900rpm. Same for my peripheral port 12A.
If you want it to idle like ****, raise the idle up over 1500 or so.
Thread Starter
Can Post Only in New Member Section
Joined: Aug 2019
Posts: 2
Likes: 0
From: Brisbane
Thanks Pee jay, It sounds like it runs half power ? then coughs a bit then the brap kicks in and its smooth , untill then its producing no power un driveable. like the port is blocked?
Thread
Thread Starter
Forum
Replies
Last Post
