Hello i have donne de swap of cdoo9 with a 13brew engine in my fc . I post some pic here for the info . You need to redrill the adaptor plate from collins if you want a good alignement with the engine .

 

Cosmo bellhousong , rear automatic plate , cosmo or fd auto starter, custom flywell , custom tranny support , gktech shifter kit ,custom drive shaft , upgrade release bering , nissan clutch disque , fc pressure plate

 

 

always nice to see more transmission options - Couple questions though

How far is the shifter back from the stock location? Without the dash in place and that cut in the floor its tough to tell exactly where it's located.

When you say you has to re-drill the collins adapter, do you mean that it's the proper conversion plate but the holes are slightly off, or it's for a different application and you've modified it to fit the cosmo bellhousing?

 

First verry sorry for my bad english . Only 1 bell housing fit with these plate . The cosmo auto . collins make the the plate off . There is a picture without re-drill. You can see de top of the tranny dont fit with the top of the bellhousing.

 

The tranny support home made is there only for show the angle of the tranny witout re-drill

 

Here with the re-drill plate ,

 

The mesure aproximative