13brew with cdoo9
https://cimg3.ibsrv.net/gimg/www.rx7...93e6cc30fb.jpg
https://cimg4.ibsrv.net/gimg/www.rx7...1f39807074.jpg Hello i have donne de swap of cdoo9 with a 13brew engine in my fc . I post some pic here for the info . You need to redrill the adaptor plate from collins if you want a good alignement with the engine . |
Cosmo bellhousong , rear automatic plate , cosmo or fd auto starter, custom flywell , custom tranny support , gktech shifter kit ,custom drive shaft , upgrade release bering , nissan clutch disque , fc pressure plate
|
|
always nice to see more transmission options - Couple questions though
How far is the shifter back from the stock location? Without the dash in place and that cut in the floor its tough to tell exactly where it's located. When you say you has to re-drill the collins adapter, do you mean that it's the proper conversion plate but the holes are slightly off, or it's for a different application and you've modified it to fit the cosmo bellhousing? |
First verry sorry for my bad english . Only 1 bell housing fit with these plate . The cosmo auto . collins make the the plate off . There is a picture without re-drill. You can see de top of the tranny dont fit with the top of the bellhousing.https://cimg2.ibsrv.net/gimg/www.rx7...676687c982.pnghttps://cimg3.ibsrv.net/gimg/www.rx7...9f433be6ff.png
|
https://cimg3.ibsrv.net/gimg/www.rx7...02c8aa2bf4.jpg
The tranny support home made is there only for show the angle of the tranny witout re-drill |
Here with the re-drill plate ,https://cimg7.ibsrv.net/gimg/www.rx7...13dbbfc2dd.jpghttps://cimg4.ibsrv.net/gimg/www.rx7...b2dfa0993e.jpg
|
The mesure aproximative
|
|
At this time the kit didnt work / fit whit all the thing that is supposed to |
All times are GMT -5. The time now is 11:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands