Will ask the guy to send me clearer photos, what kind of impact will this have?
If it is going to cause issues then he must source another one and do it properly.

 

Im sure he can polish it out bro

 

Ya it shouldn't be an issue as long as the surface is still flat which I'm sure it is

 

Redid the wiring harness this weekend, deleted a lot of things that where just left in the harness.

Before



After

 

Did some engine bay stripping this weekend and started on the sanding of the engine bay, wow what a mission to and all those nooks and crannies :shock:

Before



After

 

Started with the sanding down of the engine bay, a lot of work considering I need to get through 3 layers of paint to get to the bare metal but went pretty fast, managed to do most of the left side on Saturday.

 

Parts are back from engineering, rotors balanced and lighten and irons dialled.
Will be cleaned and prepped for rebuild this weekend

Sorry for the poor quality images.

 

Housings cleaned and ready for assembly.
again sorry for bad pic, my builder dons know how to take good pics

 

If you dont mind me asking, what is the cost to have the rotor lightened?

 

Coming along nicely

 

I like where this is going , keep the nice work , I'm subscribing

 

Cost me around $400 to get both lightened but that is here in SA. Could be cheaper your side.

 

Thanks man!

 

Yeah hopefully can get everything back in by end of April and drive it finally.

 

Cool then you me and warren can go for a breakfast run in May

 

Hopefully bud, moving at the end of April so I doubt I will have everything done.

 

Here is what I did this weekend.

Striped front bumper off



Striped venders off



Sanded almost all areas of engine bay, just need to do the fire wall and done, will do that on Friday and spray down primer, hopefully get at least one layer of paint on too. Then the rest on Saturday.
Engine should be done this weekend and can therefore go in the following weekend.

 

Some pics of the engine after engineering

 

Ok so was busy this weekend, got lots of photos, enjoy

Engine bay wrapped up and ready for primer





2 x coats of primer done





2 x coats of colour





2 x coats of gloss clear





Colour shift








I started the reassembly of the front wiring harness, rewrapped the entire harness and found some shorted out wires which I took car of, will post some pics of the wiring harness reinstalled.

 

Spent some time redoing the dash board wiring harness last night here is a before an after photo

Before



After

 

Engine done

Solid corners


assembled





Sorry again for the poor quality pics, the builder has a old phone.

 

are you taking these photos with a potato?

 

The bay looks great! Now lets get some videos of her running

 

hahahaha, i think my Builder is, these photos are from my the guy that built the engine so have no idea what he is using.

 

Thanks bud, yeah came out better than I thought it would have.

Should be up and running by mid may, hopefully