93 Digicamo "The Beater" RX7
11-11-12, 10:35 PM
#180
as posted elsewhere my diff cried like a baby...
Starspec 265s were no where near good enough to handle our cam/heads ls3.. so we had some 285 rs3s laying around and slapped them on the rear. Since they were new had to do a safety burnout to clean off the tires. Yeah bad idea...
Burned 1st, went for 2nd let the clutch out then bang akine to the sound of a 45 going off. now the carnage.
Rear cover is cracked, giant holes on both sides... can visaully inspect the whole innards. hinson ppf with a banzai diff brace modded onto it. Ls3 with around 460 whp + gobs of torque. byebye diff
Soo time for minor cosmetic things! Put these on,.
Starspec 265s were no where near good enough to handle our cam/heads ls3.. so we had some 285 rs3s laying around and slapped them on the rear. Since they were new had to do a safety burnout to clean off the tires. Yeah bad idea...
Burned 1st, went for 2nd let the clutch out then bang akine to the sound of a 45 going off. now the carnage.
Rear cover is cracked, giant holes on both sides... can visaully inspect the whole innards. hinson ppf with a banzai diff brace modded onto it. Ls3 with around 460 whp + gobs of torque. byebye diff
Soo time for minor cosmetic things! Put these on,.
12-16-12, 12:21 AM
#183
brap brap
Join Date: Jul 2011
Location: Gainesville, FL
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
Here's a video of the diff destroying burnout... It doesn't seem like much but if you listen carefully you can hear a pop at 0:08.
https://www.youtube.com/watch?v=e6TLVlBZ7Po
https://www.youtube.com/watch?v=e6TLVlBZ7Po
02-02-13, 10:01 PM
#184
Been working on polishing up all the minor things on the car. Loomed alot of the harness and been freshening up the exterior.
Plasti-diped all the carbon. Was doing this to protect it from the sun and be reversible, turned out better than expected!
The inside of the bumper's wrap was coming up a little so plasti-diped that as well, I also put my feed turn/fog combo on it
Hoping to have a diff in soon to be on the road again!
Plasti-diped all the carbon. Was doing this to protect it from the sun and be reversible, turned out better than expected!
The inside of the bumper's wrap was coming up a little so plasti-diped that as well, I also put my feed turn/fog combo on it
Hoping to have a diff in soon to be on the road again!
02-14-13, 01:24 AM
#194
Ingenious door handle idea from my friend Ben(estupido owner), cut up walmart belt bolted to the window motor bracket lol!
Also put on the SFI padding on the cage
finished looming the rear harness
HAD to paint the 8.8 orange
Also put on the SFI padding on the cage
finished looming the rear harness
HAD to paint the 8.8 orange
Last edited by Ruler_Mark; 02-14-13 at 01:28 AM.
