Finally sat down and designed a PFC Commander Holder that will fit LHD 94-95 FD3s Mazda RX-7.

Our Commander Holder will securely mount the APEXi Power FC Commander allowing the driver to safely view the display screen.

Aluminum construction with black powder coat finish to match interior.

Installs in the glove box with supplied hardware.

FD3s Commander Holder

 

Installation instructions 94-95 Commander Holder Installation Instaructions

Lower glove box



Position holder so that it does not interfere with switch assemble and install self tapping screw in lower hole







Use 3/16" Bit to drill upper hole and 1/8" Allen wrench to install supplied bolt. Install spring nut on the bolt on the back side of the dash panel.







Reinstall glove box.

 

Thank u

 

Welcome

 

I purchased this and installed it per the instructions. Now I have to slam my glove box shut to get it to catch and you can see a noticeable gap. What may I of done wrong?

 

Without seeing it could not tell you what you did incorrectly. The hardware is not thick enough to keep the glove box open, so I can only guess that you did not mount it in the correct position, either too high/low or not close enough to the dash.

 

I'll try to butt it up against the dash as much as I can this weekend. I'm sure it was something I did.

 

Will this work on 95 JDM as well..

 

just saw it can't wrk on RHD

 

This product only fits the 94-95 US models. What our Canadian customers do is buy our 93 version and bend it in the opposite direction.