How often should AI nozzles be cleaned?(which nozzle should I use?)
#1
Retired Moderator, RIP
Thread Starter
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
How often should AI nozzles be cleaned?(which nozzle should I use?)
Now that I am going to hook up the System I would like to know the "maintenance aspect" of it.
My car(TII) is going to have a To4S,50 mm wastegate and 1000/2000 on a haltech Ps1000.
I need an idea as to what size of nozzle to run.Location that is preferable,( I can put it anywhere,so to speak)
And how often do the Nozzles require cleaning,how do you clean them?
Thanks in advance for any info.STYX.
My car(TII) is going to have a To4S,50 mm wastegate and 1000/2000 on a haltech Ps1000.
I need an idea as to what size of nozzle to run.Location that is preferable,( I can put it anywhere,so to speak)
And how often do the Nozzles require cleaning,how do you clean them?
Thanks in advance for any info.STYX.
#6
Retired Moderator, RIP
Thread Starter
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I will not used tap water..that is for sure.You should see the kettle after 40 uses!The water is crap around here!
My AI kit is the old Varicool system(legacy).
I still need to know the size of nozzle if anyone can point that out.Thanks Guys!
My AI kit is the old Varicool system(legacy).
I still need to know the size of nozzle if anyone can point that out.Thanks Guys!
#7
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,894
Likes: 0
Received 114 Likes
on
66 Posts
Flow test the nozzel to varify how much water it sprays per minute at the boost psi you want to run. All you need is an air compressor, low pressure regulator, bucket but a gallon bottle is better as it collect all spray, a good timing device, some tubing, and the will to do it.
Trending Topics
#8
"Elusive, not deceptive!”
In this test both nozzles were checked for flow using calibrated containers for 15 sec. (flow = amount X 4)
Using a regulator helps check on/off of pump and flow at different pressures.
When using two nozzles there is a reduction from advertised flow.
Barry
Using a regulator helps check on/off of pump and flow at different pressures.
When using two nozzles there is a reduction from advertised flow.
Barry
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM