Not looking for vacuum lines, but the ~0.8 inch diameter 90 degree hose between the Y pipe and blowoff valve. I want something that will stand up to the heat better than the stock one; it broke in half. I was looking at ATP turbo and they have a 1 inch silicone hose, but that's too big.

 

if ATP makes one for the FD i would get it as for the 1inch diameter that why we have worm clamps

 

I think I found what I need. Ordering today.
http://www.pegasusautoracing.com/pro...asp?RecID=2097
It's a 7/8 inch hose.

 

The answer to any question about where to get stock parts is - Ray Crowe at Malloy Mazda.

His number and email is in the FAQ stickied in this forum.

 

I just went to a local parts store with the stock one, and the guy found a hose similar, and I just cut it to the length I needed.

 

Joke, I hope - worm clamps are an abomination unto the Lord.

They are almost a guaranteed failure point.

 

I disagree.....in my opinion you can't beat an IDEAL 'Tridon' worm drive hose clamp.
Lesser quality clamps...yeah, I share your opinion...but not GOOD ones like Tridons!

 

I can show you some hoses that had Tridon hose clamps on them... Oh wait, I can't. I had to throw them out when I had to replace them.