Where can I buy a TPS?
Found 93-95 at https://www.mazdatrix.com/93-95Electrical-Engine.htm
A friends car (5spd) the tps d smashed apart by previous owner so he bought a auto engine one to replace it and it been fine for well over a year...
J.
Trending Topics
If the 3G? (second from top) wire WOT doesnt respond to any adjustment and is only 5.01-5.02v, does that warrant a tps change? Or is that reading good enough.
Also, it hits 5.01v when the throttle is about halfway open, and holds it to WOT.
Also, it hits 5.01v when the throttle is about halfway open, and holds it to WOT.
Rockauto do export, use fedex from memory - no USPS, price normally not the usual courier rip. I think Malloy price was near $US150.....here, closer to $400!!
If you run an aftermarket ECU (and some plug-ins perhaps), you can adapt a garden variety 3 wire tps and avoid the second-hand lucky dip or exorbitant new prices with a spacer and an internal M8 thread on a shaft with a flat milled on it.
You could always get in touch with Ray at Malloy Mazda
https://www.rx7club.com/3rd-generati...mazda-1033616/
Are you sure you need a TPS? They don't fail that often but they do go out of adjustment.
I couldn't find them for some reason.
You could always get in touch with Ray at Malloy Mazda
https://www.rx7club.com/3rd-generati...mazda-1033616/
Are you sure you need a TPS? They don't fail that often but they do go out of adjustment.
You could always get in touch with Ray at Malloy Mazda
https://www.rx7club.com/3rd-generati...mazda-1033616/
Are you sure you need a TPS? They don't fail that often but they do go out of adjustment.
Same here. I adjusted my TPS because my idle was ridiculously out of whack. I was able to adjust the TPS so that it was within all the ranges except for the WOT range on the wire second from the top reads 5.01, after about half throttle to full throttle. Although my idle is much better, it's still only about 90% fixed. Does that reading mean my TPS is on it's way out or already needs to be replaced?
Thread
Thread Starter
Forum
Replies
Last Post
barkz
Power FC Forum
37
Nov 21, 2020 09:34 AM
Apoc3D
2nd Generation Specific (1986-1992)
10
Sep 5, 2015 10:24 AM






