onemeansaturn

I noticed that there are three (I think) nipples coming off of the UIM facing the passenger side fender that have nothing going to them on my car. Can anyone tell me what they are supposed to be hooked up to? Thanks in advance.

Joe

Mahjik

iTrader: (1)

Largest one (closest to the firewall) = Brake booster vacuum line

The two smaller ones can either be capped or used for the following:

1. BOV (ABV)
2. Boost gauge

DrunkenBowler

Damn, beat me to it!

onesick7

Mahjik: beat me to it!

onemeansaturn

Many thanks. I thought all three looked pretty small, but I will double check when I get home and have access to the car.

Joe

oorx7

iTrader: (2)

Are you sure that you mean UIM instead of the LIM? Are you still using the stock twinns?

onemeansaturn

Sorry. I think you are right. It is actually the LIM. I thought that the UIM extended a little lower than it does. I'll double check when I get home, but looking at the FSM, I'm thinking it is on the LIM. I am running a single.

Joe

oorx7

iTrader: (2)

If it is in dead the the LIM. There are 4 tubes that extend through the manifold, They are not vacuum sources. They are not used if you are single turbo.

Brandon

GoodfellaFD3S

iTrader: (213)

If that's the case, then you're fine. They're just pass-throughs for emissions components. If you're running a single setup, then most likely they're not being used.

GoodfellaFD3S

iTrader: (213)

Chris, if you're going to keep posting, how about you update this debacle of a thread?

https://www.rx7club.com/bad-fugly-members-185/issues-me-seller-chitownr1-midwestbest-mwb-drifted7-tyrant-tt-615307/page7/

onemeansaturn

Double checked when I got home it was definitely the four pass-throughs for emissions stuff on the LIM. Thanks for the help.

Joe