Hey sorry guys I've done some searching with no luck, the link I used to have with the parts manual in PDF no longer works. Can someone point me in the right direction? I was painting my calipers and had the car jacked up and noticed a rubber boot on the front was torn and I could see grease in there...is that a cv joint? lol I'm dumb when it comes to anything other than motor haha Any help would be greatly appreciated!

Jason

 

if it's front it can't be CV joint because rx7 are rear wheel drive cars.

 

I told you I'm dumb, it's a rubber boot up front with grease in it, that's all I know, I'm trying to find out what it is...

 

I bet your talking about your tie rod end. It has a little rubber cover and goes on the spindle.

 

That's probably it, if no one can send me a link to the parts manual I can take a pic tomorrow when I go finish the rear caliper paint...hopefully that will help me find out what I need to get and how easy of a fix it is or isnt...

 

Did you try the sticky thread on the top of the 3rd gen forum?? It has quite a few manuals for download.

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/94-fsms-available-download-449950/

 

Thanks for the good info but I have the workshop manuals, just trying to locate the parts manual, doesn't matter what year...like I said I used to have it but it's very elusive now Thank you though!!!

 

PM me an email address and I'll start sending them to you. It's about 19mb total in 5 files.

 

or you can go to iluvmyrx7.com Thats where i downloaded mine from!

 

I tried that, the site no longer works...

 

oh...
Mahjik, how recent/what year is your parts manual? I PM'd you also!

 

It's a '93 but they are fairly close.