Hi there, I have a question.
I have recently been doing some work on my fuel system. I had the primary injectors out for the first time since iv had the car (7 years or so).

Anyway, I removed the primary fuel rail etc, and figured I would replace the rubber o-ring type thing that seats into the intake manifold..

So, i ordered what I thought were the right parts from mazda but what I ended up with is not what I was looking for, but it got me thinking perhaps I was missing an o-ring all along.

Heres a pic I graffitied to explain what I mean (not my pic/fuel rail)



So basically, the o-rings I was trying to replace fit where the black lines are/seat into the intake manifold.
What I received is not correct, BUT it could fit on the lower part where I have drawn the red lines. Which made me think maybe I have been missing an o-ring all along?
Of course I may literally just have the wrong part.

Can anyone tell me if an o-ring/gasket only goes where the black lines are? or should there be an o-ring/gasket where the red line is as well?

It would also be really awesome if someone could help me out with the correct part number for the gasket/o-ring that goes where the black lines are.

thanks!

 

Only where the black line is.

nothing else on the outside.

 

Awesome, thanks for that!
Now just need to figure out the correct part

 

The bottom of the rail will rest against the diffusers.

https://www.rx7club.com/3rd-generati...estion-741813/

 

 

93-95 Rx7 Lower Primary Fuel Injector Grommet...

 

You are the man! Thanks so much for that.
+100 likes A++ performance