No boost (help) Non-sequential
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2003
Location: N/A
Posts: 1,109
Likes: 0
Received 0 Likes
on
0 Posts
No boost (help) Non-sequential
Ok I jsut converted back to non sequential. And I cant get any boost.
Before you try and help I might add the turbo actuator (cylinder looking thing onthe bottom of the twins with a rod sticking out) has two hoses comming off it and I did not plug them in anywhere. I have no idea where those hoses go.
Before you try and help I might add the turbo actuator (cylinder looking thing onthe bottom of the twins with a rod sticking out) has two hoses comming off it and I did not plug them in anywhere. I have no idea where those hoses go.
#4
Rotary Freak
iTrader: (8)
Mike, You need to plug the one nipple from the turbo....you can't leave it open. The other line from the turbo to the actuator has to have some kind of boost control ( pill in the vacuum line or a controlled ). A manual controller would be your best route, that would replace the soleniod and the "T" set-up you have. Call me.
Last edited by JDK; 07-09-05 at 08:29 PM.
#5
BOOOYAHHHH!
I take it you dood poor mans converstion
the 2 vaccum lines that go to the TCA need to be CAPPED!
http://www.nopistons.com/forums/inde...st=0&p=735806&
That link is the best writeup i could find
the 2 vaccum lines that go to the TCA need to be CAPPED!
http://www.nopistons.com/forums/inde...st=0&p=735806&
That link is the best writeup i could find
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM