no boost after poor mans non-seq. Help!
#1
White is tight
Thread Starter
Join Date: Sep 2002
Location: Tucson, AZ
Posts: 1,208
Likes: 0
Received 0 Likes
on
0 Posts
no boost after poor mans non-seq. Help!
I decided to do the "poor mans" pictured here https://www.rx7club.com/3rd-generation-specific-1993-2002-16/poor-mans-non-seq-my-experience-442487/
I took it for a drive and there was no boost at all. The boost gauge never went past 0. I decided to try it because my seq. system never worked right. I have a PowerFC so I unpluged the wastegate actuator and pre spool under the manifold and just used a man. boost controller. Do I need to plug the wastegate plug under the manifold back in? If so how do I know what plug goes where? Also do I need to change the setting on the PFC to non-seq.? Is this how I should have the boost controller setup?
Thanks in advance.
I took it for a drive and there was no boost at all. The boost gauge never went past 0. I decided to try it because my seq. system never worked right. I have a PowerFC so I unpluged the wastegate actuator and pre spool under the manifold and just used a man. boost controller. Do I need to plug the wastegate plug under the manifold back in? If so how do I know what plug goes where? Also do I need to change the setting on the PFC to non-seq.? Is this how I should have the boost controller setup?
Thanks in advance.
Last edited by fdeeznutz; 08-02-05 at 05:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM