3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Need Some Help

Thread Tools
 
Search this Thread
 
Old 03-23-08, 11:10 AM
  #1  
Junior Member
Thread Starter
 
kazzzt's Avatar
 
Join Date: Mar 2008
Location: Edinburgh
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
Question Need Some Help

I currently have another thread open https://www.rx7club.com/suspension-wheels-tires-brakes-20/handling-problems-my-rx7-741145/ but i have a few other question which i would like to open up to everyone,

My rx7 seems to have a black box marked blitz turbo scramblem to the top left hand corner under the bonnet,

I then have a control in the glove compartment, with buttons named,

On/Off Low, High, ST, SB, Scramble, i was hoping to find out if anyone could shed any light on what this does and how it can affect the vehicle.

I also have another pad to the left of gear box which is an apexi one which i believe is in relation to the water temp,

This has buttons named

Peak, Warn and two other i cannot remember the name off,

Can anyone shed some light on this?


I also had problems this morning starting my rx7, on insertion of the key and trying to turn over the car, the car did not do anything not even try to turn over, i eventually managed to get the car to turn over, is this a battery problem or flooding or something else perhaps?

I have been advised in respect to my rx7 losing traction on tightish - tight corner (even at very low speed) to change the tyres, align the wheels and also raise the car through the coilovers.

I have also come accross something named a D-Box used for drifting etc, and was hoping if anyone could direct me to where the steering servo is located to check if the car has a D-Box fitted, i was told that the car had an uprated diff, but i cannot see the diff affecting the car to the extend of what is happening.

The clutch is also up-rated (which is a nightmare also) when this clutch is pressed fully to the floor i am getting a strange noise (almost like scratching, this may not be the best way to explain it but i cant think of any other way)

There are a few mods to the engine which i am completely unsure of what they are not sure if you can see any of them from the picture provided,



Any help would be much appreciated,


Many Thanks


Sandy
Attached Thumbnails Need Some Help-engine.jpg  
Old 03-23-08, 11:42 AM
  #2  
Junior Member
Thread Starter
 
kazzzt's Avatar
 
Join Date: Mar 2008
Location: Edinburgh
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
Need help :P Please Help anyone? :P lol
Old 03-23-08, 12:02 PM
  #3  
I win

 
skir2222's Avatar
 
Join Date: Jun 2004
Location: NJ
Posts: 1,875
Likes: 0
Received 2 Likes on 2 Posts
The blitz controller thing sounds like a electronic boost controller, apexi thing sounds like a gauge of some sort.
Old 03-23-08, 12:40 PM
  #4  
Eats, Sleeps, Dreams Rotary

iTrader: (4)
 
BigIslandSevens's Avatar
 
Join Date: Apr 2003
Location: Denver, NC
Posts: 3,531
Likes: 0
Received 0 Likes on 0 Posts
snap some pics of the instruments in question and post them up so we can see them. Unless someone has the exact thing it will be hard to say for sure without seeing it. And even then it may be difficult.
Old 03-23-08, 12:48 PM
  #5  
Junior Member
Thread Starter
 
kazzzt's Avatar
 
Join Date: Mar 2008
Location: Edinburgh
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
Dave you back \o/ ill take some pics in 10mins, ok if i private message u?
Old 03-23-08, 01:30 PM
  #6  
Junior Member
Thread Starter
 
kazzzt's Avatar
 
Join Date: Mar 2008
Location: Edinburgh
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
Here are some pics although rather blurry due to the flash
Attached Thumbnails Need Some Help-dscf1517.jpg   Need Some Help-dscf1518.jpg  
Old 03-23-08, 01:33 PM
  #7  
Junior Member
Thread Starter
 
kazzzt's Avatar
 
Join Date: Mar 2008
Location: Edinburgh
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
/
Attached Thumbnails Need Some Help-scram.jpg  
Old 03-23-08, 02:24 PM
  #8  
Eats, Sleeps, Dreams Rotary

iTrader: (4)
 
BigIslandSevens's Avatar
 
Join Date: Apr 2003
Location: Denver, NC
Posts: 3,531
Likes: 0
Received 0 Likes on 0 Posts
Yep, I am back like the clap!!

The first p[ic next to the cd or md is to blury for me totell.

The second pic is the electronic boost control solenoid ,that monitors and activates the wastegate pressure.
Third pic is blury but it looks like the controller unit for the boost controller.

If you can get model #'s or whatnot you can look upi the manual online, probably download it from Blitz.. You should be able to see what each setting is without haveing to actually drive and watch the boost gauge.
Old 03-23-08, 03:17 PM
  #9  
Junior Member
Thread Starter
 
kazzzt's Avatar
 
Join Date: Mar 2008
Location: Edinburgh
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
The first pic, is the one that has something to do with my water temp, i can set it to warn me when it reaches a certain temp, or set a peak etc i think :S




All times are GMT -5. The time now is 07:56 AM.