Motor mounts... Did I install them wrong??
#1
Motor mounts... Did I install them wrong??
I'm about to install the PPF and noticed that the height of the motor mounts are different from my point of view. The right one has two threaded mounting points and the left doesn't.
Also the one on the right seems to sit higher than the left.
Is this normal? Do I need to switch them? Also I'm seeing the bottom of the transmission at an angle. Is this normal.
Also the one on the right seems to sit higher than the left.
Is this normal? Do I need to switch them? Also I'm seeing the bottom of the transmission at an angle. Is this normal.
#2
RX-7 Bad Ass
iTrader: (55)
- Yes the trans is at an angle, that is all good.
- Those threaded holes are for a heat shield that's supposed to bolt to the passenger side mount. It's a really good idea, I'd track one down, the heat from the exhaust can kill that motor mount over time.
Everything looks good under there to me.
Dale
- Those threaded holes are for a heat shield that's supposed to bolt to the passenger side mount. It's a really good idea, I'd track one down, the heat from the exhaust can kill that motor mount over time.
Everything looks good under there to me.
Dale
#3
RX-7 Bad Ass
iTrader: (55)
Also only the passenger side should have those holes for the heat shield. Some people have used the same arm on both sides which is fine but only one side needs the heat shield.
Dale
Dale
Thread
Thread Starter
Forum
Replies
Last Post
notveryhappyjack
1st Generation Specific (1979-1985)
12
05-22-13 08:53 AM
Mindspin311
2nd Generation Specific (1986-1992)
15
12-13-12 09:21 AM
J-Rat
2nd Generation Specific (1986-1992)
16
01-13-03 03:16 PM