Intercooler hard-pipe
#1
Intercooler hard-pipe
Does anyone know if RE Amemiya, HKS, or some other brand makes a stock intercooler HARD-pipe that duplicates the tight bend of the stock plastic-pipe that goes from the bottom of the intercooler to the Y-pipe outlet ?
After installing a Fluidyne radiator, the clearance between the crank-pulley and the VERY thick SR Motorsports SMIC is nil!
:-( neil
After installing a Fluidyne radiator, the clearance between the crank-pulley and the VERY thick SR Motorsports SMIC is nil!
:-( neil
#2
Eats, Sleeps, Dreams Rotary
iTrader: (19)
Something like this?
RE Amemiya
http://cgi.ebay.com/ebaymotors/RE-Am...QQcmdZViewItem
HKS:
http://cgi.ebay.com/ebaymotors/HKS-S...QQcmdZViewItem
RE Amemiya
http://cgi.ebay.com/ebaymotors/RE-Am...QQcmdZViewItem
HKS:
http://cgi.ebay.com/ebaymotors/HKS-S...QQcmdZViewItem
#3
Something like this?
RE Amemiya
http://cgi.ebay.com/ebaymotors/RE-Am...QQcmdZViewItem
HKS:
http://cgi.ebay.com/ebaymotors/HKS-S...QQcmdZViewItem
RE Amemiya
http://cgi.ebay.com/ebaymotors/RE-Am...QQcmdZViewItem
HKS:
http://cgi.ebay.com/ebaymotors/HKS-S...QQcmdZViewItem
Yes, but do they DUPLICATE the sharp bend and depth.
In other words, is their bend radius just as short as the stock plastic one.
:-) neil
#6
Eats, Sleeps, Dreams Rotary
iTrader: (19)
I put a couple Samco hoses in there when I installed my Arc SMIC. They definately don't take anymore room than the stock piping. If I were to bet, I'd say they take even less room under there.
Here's a couple pics. Sorry they kinda suck...it's tough to get the camera to focus in there.
Here's a couple pics. Sorry they kinda suck...it's tough to get the camera to focus in there.
#7
I put a couple Samco hoses in there when I installed my Arc SMIC. They definately don't take anymore room than the stock piping. If I were to bet, I'd say they take even less room under there.
Here's a couple pics. Sorry they kinda suck...it's tough to get the camera to focus in there.
Here's a couple pics. Sorry they kinda suck...it's tough to get the camera to focus in there.
who did you get your SAMCO intercooler hoses from, esp. the lower one near the crank-shaft/e-shaft pulley ?
TIA,
:-) neil
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM
MILOS7
3rd Generation Specific (1993-2002)
0
09-18-15 03:39 PM
Devon300zx
2nd Generation Specific (1986-1992)
3
09-17-15 03:50 PM