Intercooler hard-pipe
 

Does anyone know if RE Amemiya, HKS, or some other brand makes a stock intercooler HARD-pipe that duplicates the tight bend of the stock plastic-pipe that goes from the bottom of the intercooler to the Y-pipe outlet ?

After installing a Fluidyne radiator, the clearance between the crank-pulley and the VERY thick SR Motorsports SMIC is nil!

:-( neil

Something like this? :)

RE Amemiya
http://cgi.ebay.com/ebaymotors/RE-Am...QQcmdZViewItem

https://i15.ebayimg.com/02/i/000/88/af/68b0_10.JPG

HKS:
http://cgi.ebay.com/ebaymotors/HKS-S...QQcmdZViewItem
https://i20.ebayimg.com/07/i/000/90/b8/b087_1_sbol.JPG

Yes, but do they DUPLICATE the sharp bend and depth.

In other words, is their bend radius just as short as the stock plastic one.

:-) neil

I would think they should be the same. like the "S" pipe that comes with the greddy hard pipe kit is a direct stock IC pipe replacement.. Will only make sense for the bend to be the same to fit the stock intercooler. Although it may stick out a bit more with rubber cuplers

they fit fine. my gf got the greddy one's on here bat

I put a couple Samco hoses in there when I installed my Arc SMIC. They definately don't take anymore room than the stock piping. If I were to bet, I'd say they take even less room under there.

Here's a couple pics. :icon_tup: Sorry they kinda suck...it's tough to get the camera to focus in there.

Natey,

who did you get your SAMCO intercooler hoses from, esp. the lower one near the crank-shaft/e-shaft pulley ?

TIA,
:-) neil

I got 'em from Hop Up.

http://www.hopupracing.com/sasiinhokit21.html