Intercooler Coupler
#1
Full Member
Thread Starter
Join Date: Sep 2005
Location: Prairie Village, Ks
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Intercooler Coupler
I really hate to ask this question, but here it goes. I've been to all the autoparts stores and to Home Depot, Lowes, and RX7Store. I am looking for the intercooler coupler that comes from the IC to the piping. It is warped but I believe the size is 2.75" on one end and 3.25" on the other. Does anyone have any ideas for other places to look? All the other couplers I have on it are a straight 2.75" I believe and can be found at RX7 store. Just not this one. I didn't want to ask a stupid question but I can't find it and I'm out of ideas of where to look. Oh yeah I don't know if it makes a difference but it's a Greddy FMIC. Thanks.
Danny.
Danny.
#2
try these guys. it's what i used. http://www.hightempsilicone.com/
maybe double check you ic pipe diameter. i would think it should be 3" or less
also, if your piping is out of round, stop by autozone and rent an exhaust expander to make your pipes round again
maybe double check you ic pipe diameter. i would think it should be 3" or less
also, if your piping is out of round, stop by autozone and rent an exhaust expander to make your pipes round again
#3
Full Member
Thread Starter
Join Date: Sep 2005
Location: Prairie Village, Ks
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by GTI337
try these guys. it's what i used. http://www.hightempsilicone.com/
maybe double check you ic pipe diameter. i would think it should be 3" or less
also, if your piping is out of round, stop by autozone and rent an exhaust expander to make your pipes round again
maybe double check you ic pipe diameter. i would think it should be 3" or less
also, if your piping is out of round, stop by autozone and rent an exhaust expander to make your pipes round again
Your right I think the measurements are off because I can't find the tape measurer. Thanks for that link, I think I may have already found the one I need. I just need to find the tape measurer to make I have my measurements correct. Also I meant the coupler was warped not the piping. But nonetheless thanks for the heads up.
Danny
#5
Full Member
Thread Starter
Join Date: Sep 2005
Location: Prairie Village, Ks
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by c00lduke
ATP.com should have it. I was thinking you just needed a normal one for a bit and was going to say you could come by and pick one up.
Wow your right by me. I appreciate that you would offer that. I would like to meet someone else with an FD, I know noone that has one.
Danny
#6
Rotary Freak
Trending Topics
#8
Full Member
Thread Starter
Join Date: Sep 2005
Location: Prairie Village, Ks
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
I don't have the stock intercooler. Every other coupler is a straight length 2.75" except for this one. It is a reducer coupler where one end is 2.75" and the other is 3.25". It's connecting the IC to the pipe. Thanks by the way, baker precision had the one I needed.
Danny
Danny
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM