View Poll Results: Which IC setup?
Front mount
17
23.29%
V-Mount
56
76.71%
Voters: 73. You may not vote on this poll
Intercooler Choices: F-Mount of V-mount?
04-01-05, 09:26 AM
#26
Eats, Sleeps, Dreams Rotary
Originally Posted by spekdah
I was FMIC fro a while, then I went FlatMIC for a while, but I found I had much better results with FMIC so I went back.
Hers is a pic of my FlatMIC
Hers is a pic of my FlatMIC
SMICs and V-Mounts are over rated.
I have a FMIC and have no intake temp issues...even blazing down twisty roads in 80F weather boosting 16psi on a single. However, my buddy with a SMIC gets heat soaked sometimes while driving...
Manufacturers: "Hey! lets turn it sideways and charge an ungodly amount of money for it!"
04-01-05, 11:03 AM
#27
Rotary Enthusiast
"Approx. 70% street and 30% track/autox, although its NOT my daily driver"
for driver ed track events, proper v-mount is best of all. even a 6 pass rad will not help at the big track on a hot day with a greedy type fmic install, blocking and heating air. fmic for track shoud include a big mouth front bumper, or allow some air bypass to rad. apexi and/or blitz fmic's do this.
Done right, most fmics are fine for autox and hard street use. Allows preccooling of IC while staging ... nice +.
for driver ed track events, proper v-mount is best of all. even a 6 pass rad will not help at the big track on a hot day with a greedy type fmic install, blocking and heating air. fmic for track shoud include a big mouth front bumper, or allow some air bypass to rad. apexi and/or blitz fmic's do this.
Done right, most fmics are fine for autox and hard street use. Allows preccooling of IC while staging ... nice +.
04-01-05, 03:31 PM
#28
Originally Posted by KevinK2
"Approx. 70% street and 30% track/autox, although its NOT my daily driver"
for driver ed track events, proper v-mount is best of all. even a 6 pass rad will not help at the big track on a hot day with a greedy type fmic install, blocking and heating air. fmic for track shoud include a big mouth front bumper, or allow some air bypass to rad. apexi and/or blitz fmic's do this.
Done right, most fmics are fine for autox and hard street use. Allows preccooling of IC while staging ... nice +.
for driver ed track events, proper v-mount is best of all. even a 6 pass rad will not help at the big track on a hot day with a greedy type fmic install, blocking and heating air. fmic for track shoud include a big mouth front bumper, or allow some air bypass to rad. apexi and/or blitz fmic's do this.
Done right, most fmics are fine for autox and hard street use. Allows preccooling of IC while staging ... nice +.
I agree a 6 pass radiator would not help, ideally the most pass you want is 3 pass, due to the effiecncy and flow, over that it begins starts to lose efficency and gets very restrictive. I have found out from FEED and R-Mgic that they borh use triple pass radiators and cooling problems, they both said coolant temps are under 100C even during extended periods of time on the track.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM
