Ok... so I posted a while back when I first put my rebuild into the car, the car was running (poorly, due to a stuck apex seal - not checking clearences during the rebuild, oops). Now after my second rebuild is in, all connectors hooked up, no codes, the car cranks and trys to start for a few seconds then stops until you turn the ignition off, then turn it back on and crank it again. I hooked up some injector lights to the primary fuel injectors to find out that they are only pulsing 5 times a piece then stopping. I have spark on all plugs. What in the world could be causing this? Perhaps a faulty sensor but you would think it would throw some sort of code. (BTW - when I say no codes I mean relevant ones, single turbo conversion so I have about 20 or so solenoid codes). Any help would be greatly appreciated.

 

I have somewhat the same problem, but havent addressed it yet.

keep use updated