drivelikejehu

i was changing my plugs and my hand slipped, taking this wire with it.

its a single wire, blue, with a grey sheething, and little white plug. its just below the plugs and runs directly into the bottom of the block, but i cant find where the other end of the wire is, the end that came out of the little white plug and (i think) runs towards the firewall towards the driver.

any suggestions on what wire it may be or where it runs to? if i can find the other end i can just solder it back together.

rynberg

It will be either the water temperature sensor or the knock sensor.

drivelikejehu

wow quick response, thanks!

where does it lead to?

drivelikejehu

my mistake, it leads directly into the oil pan.

Mahjik

iTrader: (1)

Oil level sensor.

drivelikejehu

checking the pictures in the FSM, this seems to be the right wire... but where does it go from here? it broke off right at the white plug. i cant find a good diagram showing its path.

drivelikejehu

i think i found it.

it seems to go directly into the harness above it. is this correct?

Mahjik

iTrader: (1)

Yep, it's a short run so it shouldn't be hard to track down.

drivelikejehu

yep that was it! problem solved.

thanks for the quick responses guys.

xblazinlv

Same thing happened to me recently, only I was un-lucky and ripped the wire right out of the sensor

I had to buy a new sensor and replace the unit.