Help please all!
#1
Full Member
Thread Starter
Help please all!
Hi all hope your all well!
could anyone tell me what sensor or connection is above the spark plugs. It leaks oil as it’s broken. Mines a RHD 92 fd. As you look it’s lower but near oil filler. Any help is always appreciated.
thanks
Jamie
could anyone tell me what sensor or connection is above the spark plugs. It leaks oil as it’s broken. Mines a RHD 92 fd. As you look it’s lower but near oil filler. Any help is always appreciated.
thanks
Jamie
#2
Original Owner
iTrader: (1)
A picture would help.
The knock sensors are immediately above the plugs. Above them and running horizontally is a major oil line. Rearward of the plugs, and just below the oil filter, is a major oil line that comes from the left oil cooler, and below that is the oil pressure sensor -- it is a black cylinder with a single wire running off of it.
The knock sensors are immediately above the plugs. Above them and running horizontally is a major oil line. Rearward of the plugs, and just below the oil filter, is a major oil line that comes from the left oil cooler, and below that is the oil pressure sensor -- it is a black cylinder with a single wire running off of it.
Last edited by Retserof; 09-01-20 at 03:06 PM.
#3
Full Member
Thread Starter
Thanks
Yes a pic would be good sorry it’s in the garage I’ll try get one tomorrow but I think your on the money with the knock sensor. I’ll look it up. Thanks very much
Jamie
Jamie
#6
Rotary Enthusiast
The oil filter pedestal (https://www.atkinsrotary.com/store/9...1-14-310A.html) has two o-rings (p/n 99541-01601) on its underside that may be susceptible to leaking. A photo would be helpful.
Last edited by Hot_Dog; 09-01-20 at 07:32 PM.
Trending Topics
#9
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,816
Received 2,586 Likes
on
1,837 Posts
#10
Full Member
Thread Starter
Thanks
Hi all thanks for input, it’s not the oil pressure sensor that’s closer to the rear of the block. This is directly above a spark plug at the front. I’ll get some pics once she’s back out of the garage.
kind regards
Jamie
kind regards
Jamie
The following users liked this post:
Sgtblue (09-20-20)
#11
RX-7 Bad Ass
iTrader: (55)
That will probably be the goo leaking from the knock sensor. ALL FD's do this. It's just a nuisance.
The knock sensor is screwed directly into the rotor housing just above the spark plugs.
Dale
The knock sensor is screwed directly into the rotor housing just above the spark plugs.
Dale
#13
Thread
Thread Starter
Forum
Replies
Last Post
Rotary Xtreemz
General Rotary Tech Support
1
05-15-02 10:03 PM