gio64

iTrader: (1)

Hi, I have a Greddy IC (used).
I don't have the piping and I was wondering if somebody can tell me the actual size/angle/length for each piece.
Thank you,
Giovanni

catch-22

iTrader: (2)

front mount, stock mount, v- mount??

gio64

iTrader: (1)

Sorry boys, SMIC.
I meant to type it when I typed IC.

Mahjik

iTrader: (1)

http://www.rx7store.net/product_p/greddy3pcskit.htm

gio64

iTrader: (1)

Thanks Mahjik, but I was more looking into getting them around here and putting them on asap...

Mahjik

iTrader: (1)

Are you trying to make your own piping?

gio64

iTrader: (1)

Well, I was going to buy universal piping, so to speak, and do that.
BTW, the kit I saw in the link you sent (maybe the picture is not what it looks like) wouldn't fit this IC, because the lower IC inlet is already facing up, unlike the one of the stock IC, which is square with the stock IC back face.
Giovanni

Mahjik

iTrader: (1)

Are you sure you have a Greddy SMIC? It seem the 3-piece kit fits for these guys:

https://www.rx7club.com/showpost.php...7&postcount=10

https://www.rx7club.com/showpost.php...59&postcount=1

gio64

iTrader: (1)

I went back in the garage to make sure.
It has "Greddy" embossed on either side of the IC and it looks exactly like the one in the pictures you sent me. The lower inlet is coming straight up, so just to use the stock pipe as a reference, the pipe I would need only has a 90 deg bend on the turbo end, not on the IC end, it would go straight down to it.

gio64

iTrader: (1)

Here's a link to a pic:
Go to the "next picture".

http://www.rhdjapan.com/jdm-low/TRUS...13B-REW-17687#

gio64

iTrader: (1)

After further investigating the link I just posted, I believe the pipes are 90 deg and 150 deg (or 30 if you want to call it that).
Opinions?

BTW, I was looking also for confirmation of the diameter, the inlets on the IC look like they are 65 mm.

Any takers?

Mahjik

iTrader: (1)

The piping should be 2.75" (or about 70mm).

gio64

iTrader: (1)

OK, is that outer diameter? Because the inner diameter I measured was around 65mm, which would be about 2.55 inches...
BTW, thank you for the assistance.
Giovanni

Mahjik

iTrader: (1)

Yes, OD (i.e. when you buy couplers, you get 2.75" couplers).

gio64

iTrader: (1)

Thanks, that I guess was a question caused by my (still considerable) ignorance of the matter. :-(

Mazdabation

iTrader: (9)

gio...i have a set in the garage now. my IC is out.....take them, copy them, buy me a few coffees

shawn