I bought the greddy smic with the trust shorty pipes I installed the ic with my greddy factory smic piping [top pipe] but it seems to have the greddy ic pushed foward Im assuming its not the correct piping for this ic. Does anyone know what hard pipes i need to get to work with the greddy smic? if you know please pm me or post up the imfo i would grestly appreciate it thanks Greg

 

The Greddy SMIC uses the same Greddy upper pipe as the OEM IC kit(that goes to the Greddy elbow). The lower pipe is an "L" shape that goes from the crossover pipe down the IC.

-Scott

 

My Greddy I/C will be here shortly... I'm curious as to why his doesn't fit with the 3 piece pipe set Greddy sells. I know the S-Pipe will need to be modded, but why doesn't the top pipe(from Greddy eblbow to I/C) work with his setup?

 

ill post a picture tonite i thought about cutting the top pipe down but if its not the right one i would rather just pick up the one i need . looks like ill be cutting the s pipe down i didnt think abut that thanks guys

 

I had no fitment issues with my Greddy SMIC and Greddy 3 piece pipe kit.

 

^Looks good, my setup should look near identical. Thanks for the pic!

 

I have additional higher res shots available if anyone is interested just PM me.

 

well mine sits at the same angle as the pictures above I thought it was suppose to sit straight up but obviously its at a slant to some degree

 

93silverbullet didn't you part that kid and turbos out for a single conversion? Or am I mistaken? Cause you have one sexy set up under the hood in those pics.

 

You are correct, motor popped last August and I decided to go (dare I say it) the LS2 route. I have everything ready to install except the subframe (still trying to decide which route to go, custom or one of the kits available) and time.

Thanks for nice comments.