a/f ratio and boost guage install question
#1
Rotary Enthusiast
Thread Starter
Join Date: May 2002
Location: Tallahassee, FL
Posts: 1,205
Likes: 0
Received 0 Likes
on
0 Posts
a/f ratio and boost guage install question
can anybody give me a pic and describe to me where the oxygen sensor is located?
I need more in-depth instructions on how to install an air/fuel ratio and boost guage
I need more in-depth instructions on how to install an air/fuel ratio and boost guage
#5
Rotary Freak
Garfinkle taps the wire at the ecu , shorter, out of the heat, out of the vibration, out of dirt and oil . The senser is in the down pipe at the turbo end, remove your top air intake tube ect. ect . to get to it . the stock one has one black wire out of the top .
#7
Rotary Enthusiast
Join Date: Mar 2002
Location: DE, Taiwan
Posts: 751
Likes: 0
Received 0 Likes
on
0 Posts
Boost and A/F...that's what I need to get done soon. What's the best way to run wires/hoses through the dash? I was just gonna go with APEX'i black face for the boost to keep the stock color scheme in the cockpit. Is having the Link for additional gauges really worth the extra money? Any estimation for how much time it'll take me and a buddy in a garage full of tools and a golden retriever (he's lucky)? I don't wanna try doing it during the week and end up driving around with **** hanging off my A-pillar.
Thanks
Thanks
Trending Topics
#9
Full Member
Join Date: Jul 2002
Location: Chicago, IL
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Just make sure you tap into the right wire on the ecu. I tapped the wrong one and could not figure out why my gauge was acting goofy. Also make a good ground connection.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM