When removing the wiring harness the CAS clip got ripped off. Fortunatley the EGR clip is the same so I was able to use that instead. Now there are 2 clips for the crank angle sensors. Do the wires on each clip connect in the same order, or are they reversed? I am assuming they are the same, but I wanted to make sure.

Thanks,
Dan

 

Not sure, but it should be documented in the shop manual pretty clearly. I have a feeling that polarity doesn't matter, but with the crank angle sensors it's better to be on the safe side - that's such a key input to the ECU. I'd do it right bigtime.

Dale

 

To test the resistance it doesn't say anything about using positive on one end and negative on the other, I'll just double check my friends (if i can reach it) to make sure they are the same.

 

Just check the wiring diagram in the shop manual - it will have the connectors clearly labled with the wire color and position.

Dale

 

it doesn't matter they are the same

 

yup, page G16 has the diagram for it...looks like it's the same to me

Thanks again

 

The white connector goes on the higher/upper CAS, the grey one attaches to the lower one. Do you know which one you removed?

 

oh, yeah I know which order they go in, I removed the gray one i believe.. I just didn't know which wire went in which order.