So is there anything that i should remember doing before firing her up for the first time, is there anything that can be fatial. I hope this thing runs and runs good. Any suggestiond no matter how dumb. Thanks Marc

 

Is this on a rebuilt engine or something? If it's a rebuild, make sure to let it warm up, and break it in properly. If it's something else, then please specify.

 

ya sorry its a rebuilt engine and its her first time. I am putting it my myself this is why i ask. I hope this makes sense. i got the basics like tranny fluid, motot oil, anit freeze, but do i have to get oil presure going before the first fire up. Stuff like that. Thanks

 

You can turn the engine over, while holding the gas all the way down to spin the engine over a few times before cranking it. That will get the oil pump goinig. You don't really have to, though.

 

prime the fuel system for 10 or so secondos.

 

MMONACO, I HOPE YOUR NOT PUTTING THAT MOTOR IN WITHOUT ME!

 

Pull the fuel pump fuse, and turn it over for a few seconds. then fire it up..


Let it idle for a good 15 minutes. while it is idleing watch for leaks!

And after that turn it off and check for leaks.. if everything is ok, start it back up and take it for a ride. Don't go over 3K for 1000 miles


This engine has used bearings???

if it has new bearings break in should be done for about 3K miles..


-Zach

 

He never said it has used bearings...?

 

That was a question sorry

Most engine rebuilds have used bearings.. Unless you specify you want new ones..


-Zach

 

hey i am not sure if they are used bearings... HMM thats a good point ill check into this. Thanks FOr the input guys. ANything else

 

I did that and my engine fired right up. The revs jumped up before I relized what was happening to let off the gas. I have the PFC though.

 

dsag