does anyone make the braket/plates to adapt the manual tranny to the auto chasis??

 

As far as I know it bolts right up with the exception of 1 bolt at the engine. Are you referring to the companion flange on the differential?

 

In bracket you mean the tunnel bracket? it the same i with think. I did the swap so far i didnt run into to any problem.

 

ummm well i did an auto to manual swap on my 1990 rx7 convertible and the manual transmission mount was about 3 inches further back than the chasis,i dont know if its the same with Fds i just thoguth i would ask.....so in other words i can mount a manual transmission on my fd and it will bolt right up to the chasis?

 

no one?

 

Yeah it will bolt right up. You will need longer bolts to mount the tranny to the auto engine though. There are two really good write ups under the FAQS.

 

i cant find the write up, does anyone know where to get it?

 

Auto to Manual Transmission swap:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/automatic-manual-swap-how-hard-anyone-done-96658/
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/so-how-many-people-have-done-auto-manual-swap-258966/

and FYI look at the sticky s at the top of the 3d gen section

 

I have all the parts to do a conversion if your interested