i'm looking for a Silencer insert for my HKS Super Drager exhaust..

120mm tip

unfortunately.. Apexi's only go upto 115mm.. so I'm SOL

and the car is FAR TOO loud now that it's no seq.


any suggestions?

 

google knows all

http://www.mufflerguy.com/ps-6885-35...iliateid=10050

 

Thanks bro.. unfortunately they don't take paypal

 

Are you sure the Super Dragger is only a 120mm? I have a Super Dragger, and it looks more like a 140mm tip.

Also, what midpipe/downpipe combo are you running? I find my Super Dragger to be fairly tollerable(though I've never had my car WOT, care of the fact that I'm currently breaking in the motor)


also, HKS USA's website allows you to search for dealers in your local area...
http://www.hksusa.com/products/?id=1364&rsku=5572

 

go to hksusa.com

call hks they will know what u need and where to get it. or buy direct.

 

I've wrote to RHD.. see if they can source me one.. since i have a pending order with them already..



mine is straight pipe all the way.. 3 inches.. no Cat no Res. just the HKS muffler

it wasn't THAT bad before.. after going non-seq tho.. the sound level is Retardedly loud now.. I'm guessing the sound level of a Single turbo FD would be comparable..



as for size i used a vernier caliper.. from left to right.. it was 115.X mm

so I assumed outside the outside to be 120mm since there's nothing between size wise

perhaps u have the Drager II?


here's a pic:

 

Yeah, that's not the same cat-back I have. Mine is 3.75" piping and the tip is much larger than that, and the cannister on mine is a lot larger as well. One of us must have a Dragger II. I'll double check mine later, just to verify.

Not that it matters, but here's mine. The piece of paper is 8 1/2x11, but it was too windy to hold it straight.

 

mine has "Super Drager" laser etched into the side of the tip

what does yours have written on it?

 

Mine says "HKS SUPER" on one line, then "Dragger" in their fancy schmancy font under it. You probably have a newer revision or something...

 

I have the same issue. Strangely enough a single turbo with a 3" straight pipe doesn't appeal to my neighbors as much as it does to me. I want to cure that issue with a custom dual exhuast: http://store.summitracing.com/partde...5&autoview=sku

The whole setup will cost a little more than a silencer tho.

 

my single turbo with the 3" pipe is really not that loud unless I'm at full throttle. However, I have the Racing Beat Cat back with the duel tips. I have been told that this is one or the quieter exhausts.

 

I wouldn't mind a cut out actually..

can it be controlled to "Partially close"?

or is it on/off only to Dump to atmosphere?

it would be nice to have something that can close like 40-50-60-70-80% for example.

 

You would probably need to get a manual one for that. It's a whole lot cheaper too.

 

I've always wondered how this would work.
http://www.nengun.com/apexi/active-tail-silencer