I need to hook the rear chassis wiring harness on my 90 rx7 but my connectors don't match up since i swapped my engine with the turbo engine. i switched all the hiring in the front half but dont have the new wiring for the rear. i do have the connectors that had been cut when they cut the car in half. If any body could help me out on wiring my existing harness with the connecters that fit so that i could atleast get the brake lights blinkers and fuel pump to work. The new set up has to green connectors on the driver side, and 1 white one on the passenger side. the old set up had a 1green and 1 white one that is square rather than elongated on the driver side.

 

Are you up on reading wiring diagtrams?

 

I have a little understanding of wiring diagrams. But my haynes repair manual just doesnt cover it enough. i was hoping to find something that couldtell color of each wire and location in vehicle

 

You are in luck.. There is this handy thing called the FSM, which you can download from the FAQ at the top of the page.

In it, it has the wire codes, locations, etc.

 

im not seeing this fsm, how do i get into it.

 

https://www.rx7club.com/forum/showth...ht=photobucket

http://69.162.44.72:8080/rx7/s5wiring/

 

here is the FSM http://www.teamfc3s.org/main/factory...ual/1989_1991/

 

The last time I looked, the WIRING SCHEMATICS were not in that file.