what are you guys running in the 1/8 mile?
#1
The "Original SDRotary"
Thread Starter
Join Date: Apr 2003
Location: San Diego
Posts: 428
Likes: 0
Received 0 Likes
on
0 Posts
what are you guys running in the 1/8 mile?
Took my '86 n/a out to the new track down in san diego, she ran a 9.8 at 75 mph with header, intake , exhaust, tb mod. stock port motor..
#5
mad scientist
The GTUs rear isnt that good for drag. It has a viscous LSD, that requires a wheel speed differential before it starts to lock. Basically, youre goign to have to spin one wheel faster than the other to get the LSD to start doing its job. A clutch type, on the other hand, is locked until there is enough differential torque to allow the wheels to turn at different speeds.
One of my friends has a GTUs rear with the viscous LSD, and we both agree that its not well suited to drag.
One of my friends has a GTUs rear with the viscous LSD, and we both agree that its not well suited to drag.
#6
REINCARNATED
iTrader: (4)
I'm running a similar setup minus the headers. i pulled a 9.9 at 73 mph in the 1/8th mile
My mods are in my sig.. Headers are NEXT!
-Markus
"No, i dont drag race, i just do it to compare against other cars on the road" I'd rather take a corner than drive in a strait line...
My mods are in my sig.. Headers are NEXT!
-Markus
"No, i dont drag race, i just do it to compare against other cars on the road" I'd rather take a corner than drive in a strait line...
Trending Topics
#9
The "Original SDRotary"
Thread Starter
Join Date: Apr 2003
Location: San Diego
Posts: 428
Likes: 0
Received 0 Likes
on
0 Posts
thanks for the info mazdaspeed7, the gtus rear end has a kaaz installed in it so it should help..
relisys190- that's a good time for someone w/o a header, is that motor ported?
relisys190- that's a good time for someone w/o a header, is that motor ported?
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
20B Forum
8
08-18-15 02:46 PM
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM