Turn signal/HB switch lever fell off
#1
Full Member
Thread Starter
Turn signal/HB switch lever fell off
Basically, the switch itself works fine, but the level is just sitting on the switch piece, and can be pulled right off with no resistance. Obviously not a big problem at all, but I'm very **** about my cars, so it bugs me. The switch piece looks fine, but maybe the inside of the lever is damaged? I dont want to glue it on and ruin the high beam switch. What's the best way to fix it on? Should I hunt for a new lever or is that not the problem?
#2
Hey...Cut it out!
iTrader: (4)
There is a tiny small phillips head screw with rather coarse threads that secures the lever to the switch shaft. It is roughly the size of a M2 or M3 machine screw. It should be listed in the Parts Catalog
Edit: So I just checked and found the part number. FB01-66-132. It vanished on my FC too, so I know what you're going through. Atkins Rotary says they are discontinued form Mazda, but they found another supplier and have them in stock for $2. So at least it's a cheap fix.
https://www.atkinsrotary.com/store/8...01-66-132.html
Edit: So I just checked and found the part number. FB01-66-132. It vanished on my FC too, so I know what you're going through. Atkins Rotary says they are discontinued form Mazda, but they found another supplier and have them in stock for $2. So at least it's a cheap fix.
https://www.atkinsrotary.com/store/8...01-66-132.html
Last edited by Akagis_white_comet; 02-25-22 at 12:28 AM. Reason: Additional Info
#3
Full Member
Thread Starter
edit: alright awesome. Thank you bro
Last edited by broman99; 02-25-22 at 12:30 AM.
The following users liked this post:
Akagis_white_comet (02-25-22)
Thread
Thread Starter
Forum
Replies
Last Post
Rxxx-7_GSL-SE
1st Generation Specific (1979-1985)
19
10-01-06 07:02 PM