Looking for a turbo II rear end 4.33 or higher, with ltd.
Let me know where I can get 1.
Thx
Ben

 

Mazdaspeed

 

looking for a used 1
thx

 

The only rearends that came with the 4.33 is the GTUs, are they compatible with a TII drive shaft and tranny?

 

I think a J-spec Infini IV had a 4.33 R&P, but Im not certain. N/A ones are not compatable...

 

yeah, you are going to Japan for that one if you need used, or maybe someones blown up project car where they swapped the ring and pinion out

 

Yea, infini's here in japan are the only ones i know of, stock anyhow

 

www.mazdatrix.com you can buy the ring and pinion you need, shouldn't take long or cost much with a reputable tranny shop provided you deliver them the rear already out of the car.

 

Good luck.

 

don't bother hunting a used one. I would by the ring and pinion and have it built like jon88se suggested.
maybe throw in a FD Torsen diff. unit while its apart

 

thats funny, the FD guys go to an S4 Tii diff and people talk about putting the FD diff in a Tii

 

How much are u looking at? I have a Torsen + 4.3 rearend sitting in my living room doing nothing; both are from Mazdatrix, with only 7,000 miles on them.

 

Yes I would like to buy your rear end with torsen
send me an e-mail.
Thx

 

eh, depends on what application yer goin for. I guess for super high boost/high HP drag launches i prolly wouldn't want the stock Torsen unit of the FD but for autocross, road racin and track events that FD diff is a bad *** upgrade for the FC and a lot friggin cheaper than some of those aftermarket ones.

RotaryDawg, PM me with what yer lookin to get for yer setup.