Replacement for the small rubber spacer in the warning light cluster?
#1
Junior Member
Thread Starter
Replacement for the small rubber spacer in the warning light cluster?
I just finished up replacing all the solder in my warning light cluster with new stuff, but the small rubber spacer thing for the clock came off in pieces when I disassembled it, so I was wondering where I could get a replacement.
The 35 years have not been kind to it, and it definitely needs replaced. I had to glue it back together for that picture. Any help at all would be greatly appreciated. I really don’t want to have to buy a whole new cluster because of this one piece
The 35 years have not been kind to it, and it definitely needs replaced. I had to glue it back together for that picture. Any help at all would be greatly appreciated. I really don’t want to have to buy a whole new cluster because of this one piece
#2
Rotary Enthusiast
iTrader: (9)
if you have a 3d printer, or a know someone with one, there's printable replacements on thingiverse
https://www.thingiverse.com/thing:5019521
https://www.thingiverse.com/thing:5019521
The following users liked this post:
rlynchster (05-20-23)
#4
Full Member
One potential option, I simply reused some rubber like material I had to replace my cracked “support/spacer” pieces. I just cut out the same shapes with said material, test fit the new pieces before putting it all together. It worked well and should last for many years.
Thread
Thread Starter
Forum
Replies
Last Post
FrancesTheFC
2nd Generation Specific (1986-1992)
5
03-29-23 02:36 PM