hey guys my engine blew so im going to rebuild it for boost. my question is can i put turbo rotors in a n/a? if so what other parts do i need like counter weights, ect...

 

the rotors most be of the same series for the counter weights and what not.

 

Why not just find a TII engine and then rebuild that?

 

You will need counter weights for the turbo rotors that match the weight number I think. Good luck.

+1 That's what I'm leaning towards right now.... just have to get my garage built, lulz.

 

because i already have this one and turbo rotors.
and an intercooler, bov, wastegate,turbo, and emanage from my other car so this will be cheaper

 

you can run the high compression rotors. just be safe when tuning it... i'm hoping that you wouldn't just put a stock t2 ecu on and boost 10 lbs.... you can pick up a rtek and a safc, wideband and tune it to your needs. just remember to be safe especially when in high compression motors. water/meth injection is an added safety measure... just depends on how much you want to buy. it'd be cheaper to purchase a t2 motor though.

 

Well in that case, use the NA rotors and read:

http://www.aaroncake.net/rx-7/4PortLIMTo6Port.htm
http://www.aaroncake.net/rx-7/naturbo.htm

 

stock TII parts or something else?

 

yes you can. they bolt right up, you need to tap the middle iron so the bolt can thread it, and the lower intake manifold needs to be ported (japan2la on the forum sells ported manifolds). other than that, you are good to go. youll have ot figure out some things though, but thats ok. like ECU and whatnot. which i recommend. ditch the stock ****(electronics)