I need the sizes, length and thread pitch of the following since they were not in the faq:

-Transmission to engine bolts (s4 t2 tranny to s5 t2 block)
-Clutch pressure plate to flywheel (exedy pp to act flywheel)

 

Here is a link to stock bolts I assume engine to trans are the same S4 to S5 and clutch should not change either unless they gave you new bolts.

https://www.rx7club.com/showthread.p...turbo+oil+line

 

I don't have the clutch bolts, nor the transmission to engine bolts so that is why I am inquiring on their size and thread pitch.


I just looked at the link you gave me, and I didn't find the bolts I needed. It only talked about the coarse threaded one.

 

(1) 14 mm head - Length = 145mm (5 5/8 in) (with head of bolt)135 mm (5 1/4 in) (from bottom of head of bolt to end of bolt). Nut on opposite end. FINE THREAD
(1) 14 mm head - Length = 100 mm (3 15/16 in) (with head of bolt) 90 mm (3 1/2 in) (from bottom of head of bolt to end of bolt). FINE THREAD
(2) 14 mm head - Length = 45 mm (1 3/4 in) (with head of bolt) 35 mm (1 3/8 in) (from bottom of head of bolt to end of bolt). FINE THREAD
(1) 14 mm head - Length = 40 mm (1 1/2 in) (with head of bolt) 30 mm (1 3/16 in) (from bottom of head of bolt to end of bolt). COURSE THREAD

Pressure Plate to Flywheel
M8 x 1.00
24mm long

You mean those? Both of which are in that link he posted.

And how dare you bash my list! I spent alot of time on that list and am planning on updating it soon. (Yes, I was DerangedHermit, hence the avatar)

 

That is the page I use in my favorites to get to the site. It came in handy when doing my project.

 

I was a little confused by the list, particulary the part "engine/tranny mounts"

I was in error, and I apologize.

Thank you guys for your help!