NA speedo cable works with T2 Tranny

Reply Subscribe

Thread Tools

Search this Thread

Dec 16, 2005 | 12:04 AM

SexInDaRex

Thread Starter

Rotary Enthusiast

Joined: Apr 2005

Posts: 935

Likes: 1

From: PA

NA speedo cable works with T2 Tranny

I read that I had to change the speedometer cable of my NA so that it works with the T2 tranny. Well I installed the tranny and used the same NA cable and it works the fit was tight I was under the dash but its totally possible to connect it.

Dec 16, 2005 | 08:31 AM

richardfc3s

Junior Member

Joined: Oct 2005

Posts: 14

Likes: 0

From: Bakersfield, Ca

Hey did you do a TII engine into N/A body swap?? Or are you just using a N/A speed-o cable for your TII??

Dec 16, 2005 | 10:01 AM

YearsOfDecay

Locust of the apocalypse

Joined: Apr 2003

Posts: 2,553

Likes: 2

From: Directly above the center of the earth (York, PA)

the CABLE works.. all manual transmission CABLES are the same..... but the GEAR that drives the cable off the tranny is different...

TII's have a different gear ratio in the drive train than an N/A.. Thus.. they also have a different gear that drives the speedo cable...

Your speedo is now off!!!!

Dec 16, 2005 | 10:19 AM

Houstonderk

My girl

iTrader: (3)

Joined: Apr 2004

Posts: 2,173

Likes: 3

From: Andrews AFB, MD

Can't you just switch the clusters around or are they the same? I can't picture it this morning.

Dec 16, 2005 | 10:28 AM

Tournapart

RIP Icemark

iTrader: (4)

Joined: May 2005

Posts: 1,018

Likes: 2

From: Mesa, AZ

just change the gears, who NEEDS a speedo anyways, mines been broken for months, all i need are the oil press, water temp, RPM, and gas guage and they all work fine. but you people and your proper working vehicles.....lol....