I already hooked up the MSD SCI box to the Leading Coil pack with a MSD Tach adapter. But what i whana know is that how to hook up the MSD DIS2 to the trailing coil pack with Dual Ignition Adapter. Help will be helpfull.

I reposted because i wanted to make the topic specific.

 

No need for any adapters.
If you figured out how to do the SCI, then the DIS-2 is similar.
The MSD box just goes in between the ignitor and the coils.
DIS-2 has channel1 and channel 2.
Just make sure the input and output are correct for T1 and T2.


-Ted

 

No what i was wondering is what color wire is what on the trailing coil pack cuz Dis2 has like 6-7 wires and like what is trigger 1, trigger 2 and 12 volt igniton wire colors on teh coil harness and what color are the coil (-), coil (-) and Coil (+) wires coming out of the ignition coil.

 

Kinda getting it but well...i opened up teh coil pack cover where all the wires go and its labelled cpu 1 and c1 c2 and stuff...thats what i whana know....that where do these wires go!

 

Dude, the wires are labeled right in front of you - why are you popping covers off???

Look at the "top" of the coils - one says "T1" and one says "T2".
Now you know the difference between front trailing and rear trailing...

Look at where the wires from the ignitor (base) connect into the coil.
Look at where the terminals are - one says "-", the other says "+".
Now you know which side is negative and which side is positive.

That should be all the information you need to install the DIS-2.


-Ted

 

you post a pic of the dual ignition adapter.
thanks
al

 

Hey i am Zebt66 friend we got eveything hooked up and working. The only problem now is that the Tach is not showing any rev.

 

You're not suppose to mess with the tach lead on the trailing coil packs.
I think this is the yellow wire?
If you cut this wire, you get no tach signal.


-Ted