This is a bit off topic, but what is the efficiency range of a GT30R or even a GT28R on a rotary? and what kind of numbers would they put down.

anyone know?

 

i dont need the kit just the turbo

 

Maybe you should specify what manifold, downpipe, etc. that you have then.

 

browse the single turbo section...this has been covered

 

t04R

 

if you want it on the cheap, Holset HX40/H1E .

 

would a turbo with these specs give me the 400horses??

this is a Holset WH1E

Specs:


Compressor Housing : Holset "High Flow with Anti Surge" H1E with a huge 4" (101.6 mm) inlet and 3" (76.1mm) V-band outlet.

Compressor Wheel Diam : "Fast Spooling" 2.283" (58.0 mm) Inducer ("Small side") and 3.268"" (83.0 mm) Exducer ("Large side") diam.

Turbine Housing : T4 Style 19 cm (Close to 1.00 A/R) with a 4" (101.6 mm) V-Band exhaust flange.

Turbine Wheel : Super High Flow 2.518" (64 mm) Inducer ("Small side") and 2.918" (74.1mm) Exducer ("Large side") diam.

Center Housing : Oil-cooled.

Turbine Inlet Flange Footprint : T4 Divided.

 

HOW ABOUT THIS ONE???

Garrett T3/TO4E hybrid turbocharger

Compressor: .70AR
Exh. .63AR

Standard 5 bolts T3 flang

Stage III turbine wheel.

57 trim

 

would ^^^^ that one work??

 

or how about this one??

TURBONETICS T3/T04S "T72" TURBO

SPECS:

TURBONETICS T3/T04S "T72"

COMPRESSOR HOUSING: T04S A/R 70, 4"IN. 2.5 OUT (POLISHED)

COMPRESSOR WHEEL: 72MM INDUCER

CHRA: OIL COOLED, 360 TRUST BEARING, NOT BALL BEARING

EXHAUST HOUSING:A/R 82

EXHAUST WHEEL: STAGE V "BIG SHAFT"