phalerider

Is it normal for RX7's NOT to have a VIN plaque on the dash under the windshield? I found the one in the drivers door jam. Is there supposed to be a plaque on the dash too?

s4Lt

No that is not normal, it should be there. You should see the little rectangle cutout in the black tinting at bottom of window and the VIN plaque should be there. If not it was probably removed by previous owner or someone else.

87 t-66

iTrader: (133)

it should also be stamped on the firewall. those plastic vents at the top of the dash crack all the time

phalerider

ok, now I'm scared. Local mazda says NO there will not be a vin by the winshield. I also found 2 1990 convertibles with a plate on the defrost vent. I've also never seen a manufacture put it on a vent, so maby its normal. I just dont want to buy a stolen car. I went over the car this morn but I didnt see that box on the lower window tinted edge that u see on most cars. I really want this car.

phalerider

forgot to mention that i'm an idiot. it never dawned on me to check everywhere else. ie firewall

Sideways7

iTrader: (7)

Unless I'm mistake its required by law. And yes, it is on the demister vent. And yeah, the three places are the firewall, door jam, and under the windshield (demister vent).

patman

iTrader: (3)

it is also stamped on the block, and i think on the bellhousing. I cant remember where it is on the block, someone back me up here...

the firewall is the easiest one tho, and you dont have to worry about a jspec motor or something throwing it off....

87 t-66

iTrader: (133)

no its not on the demister vent, those are the small triangular vents on the corners of each dash. it is in the defroster vents at the very top of the dash by the windshield.

My5ABaby

iTrader: (7)

And this is why we tend to ignore dealerships.

PinkRacer

I have an '86 and there's a vin plate in the windshield on the defroster vent piece of the dash right up by the windshield on the driver's side. Also it's on the firewall and the door jamb.

daviddeep

iTrader: (4)

I thought the number on the engine was an ID number for the engine itself that did not actually match the VIN. I think the engine number has far fewer characters/digits than the VIN. I'm gonna go look at mine later out of curiosity now that this has come up.